[How to]Install Twrp recovery in Intex Aqua Star 2


Finally it arrived 🙂
Yeah Twrp custom recovery for Intex aqua star 2 16GB

Ok Lets flash!

Requirements-

  • Intex Aqua Star 2 
  • A usb cable 
  • Twrp Recovery
  • Pc

You should also see-Flashify cracked apk

STEPS TO FLASH:-

  • Enable usb debugging.
  • Connect your INTEX AQUA STAR 2 to pc.
  • In pc Go to c:>adb
  • Paste the downloaded recovery to adb folder
  • Rename it to twrp.img (use small case ‘t’)
  • pen cmd in adb folder and type adb reboot bootloader (your device will reboot in fastboot mode)
  • Now in cmd type fastboot flash recovery twrp.img
  • It will show success
  • Type fastboot reboot (your device will now reboot normally)
  • When your device booted up in cmd type adb reboot recovery
                                                                    
If you are already rooted use flashify to flash twrp

11 thoughts on “[How to]Install Twrp recovery in Intex Aqua Star 2”

  1. Hi bro….
    successfully running TWRP,
    but problem is can't go into TWRP using volume up + power key.

    eagerly waiting for Custom ROM (Lollipop/Marshmallow)

    any solution for battery draining fast

    Thanks

    Reply
  2. Found correct way
    Press power up button then after 2-4 sec press volume up button…when the screen brighten up release both botton… 🙂
    And yeah I started working on lollipop firmware it will .PAC file

    Reply

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.